In a message dated 5/28/2003 1:39:28 AM Eastern Daylight Time,
13brv3@mchsi.com writes:

> You may be able to use the original banjo fitting on that port because
>  of the restricted space caused by the motor mount.  The banjo fitting is
>  18 X 1.5mm.  The banjo filling is restrictive and not ideal but it may
>  be easier than redo the motor mount.
>  
>  Rino
>  ------------------
>  
>  ===> Good point about the banjo fitting.  If the new connector doesn't work
>  out, I'll look into that.
>  
>  Thanks,
>  Rusty

Get the oil system schematic from the engine builder. You have to get this
right.

Lynn E. Hanover