|
|
<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
<< Lancair Builders' Mail List >>
<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
>>
HI , the problem ( without seeing it ) sounds like you just need to trim
the skins back further. the alignment of the elevator hinge points was
already factory set / installed in the manufacture of the assembly.
i expect that the hinge point alignment is straight , in that the bolts all
go into the hinges easily , and the elevators are moving up anddown easily.
the gap is measured with the elevators in the up and down position at the
full travel of degrees that the plans show.
you are not getting full travel yet , so you need to trim the skins back
more. one way is to get a long straight board , staple on some rough
sandpaper and work on removing material from the trailing edge of the top or
bottom skin. you may be able to do it with the elevator installed and work
back carefully.
watch that you do not exceed what is required , sanding and then move the
elevator up to check the amount of travel ( degrees)
the long board will help you keep a straight edge along the whole skin ,
elevator area .
you may need to remove more from the outboard edge than the inboard .
you are probably correct that the hinges are not hung with 100% acuracy at
the factory.
also install all three bolts when working on an elevator.
check that you do not have the horizontal stab upside down , i have seen
that hapen twice on the IV 's
if i can give you any advice ( or try to ) you can also feel free to call me
direct at 902 888 2916 any night after 10 pm. we are 4 hours ahead of you
in time. i live on the east coast.
...........marty
-----Original Message-----
From: Joe and Maria Santos <jmccs@home.com>
To: lancair.list <lancair.list>
Date: Wednesday, May 09, 2001 9:37 AM
Subject: ES Horizontal / Elevator Alignment
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
>
>I'm hoping someone can offer me some advice on getting the alignment
correct
>between the horizontal stab and elevators on my ES. Having gone through the
>builder's workshop, the stab and elevators were pretty much
SNIP
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
LML website: http://www.olsusa.com/Users/Mkaye/maillist.html
LML Builders' Bookstore: http://www.buildersbooks.com/lancair
Please send your photos and drawings to marvkaye@olsusa.com.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
|
|