lml@lancaironline.net Mailing List Archive

Greyhawk--

I really like your idea of putting the AoA flap switch on the flap actuator itself. I looked at mine yesterday and it seems like that would be a much simpler way to do it and it could be readily adjusted, unlike the way I did it. I would be grateful if you could provide a closeup photo or a description of how you attached the microswitch to the actuator.

Thanks--

--John

Subject:
Re: [LML] Re: AoA flap position switch

From:
Sky2high@aol.com

Date:
1/6/2014 11:53 AM

To:
lml@lancaironline.net

Right on Marv.

Here is a way to detect position on an LNC2 using the linear flap positioning motor. A curved micro switch arm rests in the groove that the stabilization rod runs in. When the rod moves through the 1/3 flap position, the switch is made and stays made until the flaps are retracted.

Grayhawk