|
|
I also just purchased Gamijectors for my IV-P/TSIO-550. I collected detailed info prior to the purchase. And they will be installed in the next week or so. I’ll collect post-installation data and submit my results. Pre-installation, my GAMI lean test showed 0.7 gph difference between first and last to lean. Not terrible, but it should be below 0.5 according to GAMI. Operating lean of peak I saw 65-70 dF difference between the hottest and coldest CHTs. I’d like that to be a lot closer. Jay Phillips From: Lancair Mailing List [mailto:lml@lancaironline.net] On Behalf Of William A. Hogarty
Sent: Monday, October 21, 2013 8:46 AM
To: Lancair Mailing List
Subject: [LML] Re: GAMIjector installation on TSIO 550 Please post results after you replace your injectors. On Mon, Oct 21, 2013 at 7:38 AM, Ron Laughlin <ronlaughlin@gmail.com> wrote: John, Order this socket that is custom made for the task:
On Mon, Oct 21, 2013 at 6:40 AM, John Barrett <jbarrett@carbinge.com> wrote: Hello All, I recently acquired a set of GAMIjectors for my TSIO 550 in N31VP. I am trying to install them and it appears I’m going to have to remove the intake stacks to be able to access the injectors. Is this correct or is there a trick or tool I don’t know about? If I do have to remove the intake pipes, do I need to replace the gaskets for the pipes when they go back in? What is the torque for the three hold down nuts on the intake pipes? Thanks in advance. Regards, John Barrett, CEO Leading Edge Composites PO Box 428 Port Hadlock, WA 98339 www.carbinge.com |
|