Good point. John
From: Lancair Mailing List [mailto:lml@lancaironline.net] On Behalf Of MikeEasley@aol.comSent: Wednesday, May 11, 2011 10:00 AMTo: lml@lancaironline.netSubject: [LML] Re: Emailing: P1010001, Elevator Access Panel Replacement
John and Bill,
Countersinking #6 screws into 4-6 BID of graphite doesn't leave much material. That's what happened to my first aluminum cover plates. I dimpled the second set and that's the way to go. Of course you could go 10-12 BID and have plenty of material for the countersinking.
Mike Easley
Colorado Springs
In a message dated 5/10/2011 9:23:51 P.M. Mountain Daylight Time, jbarrett@carbinge.com writes:
Bill, Here’s your chance to replace aluminum with graphite – make a 4 to 6 bid sheet of graphite and cut the cover out of that. John Barrett Bill Maddox wrote, Well I need a set of the original aluminum elevator side plates that go onthe fin of the 4 Michelle sent me a set that is too small and that is theonly ones she has according to her . I guess they don't have or carry theones that were in the kit If I can't find a set I'll have to make themBill
Bill,
Here’s your chance to replace aluminum with graphite – make a 4 to 6 bid sheet of graphite and cut the cover out of that.
John Barrett
Bill Maddox wrote,
Well I need a set of the original aluminum elevator side plates that go onthe fin of the 4 Michelle sent me a set that is too small and that is theonly ones she has according to her . I guess they don't have or carry theones that were in the kit If I can't find a set I'll have to make themBill
No virus found in this message.Checked by AVG - www.avg.comVersion: 10.0.1375 / Virus Database: 1500/3630 - Release Date: 05/11/11