|
If your wanting the "elephant butt" I have one that you can have
for free, just pay shipping.
Steve
Buller
IV kit #399 1400 hrs
269-209-5841
I was getting ready to start on the IV-P baggage area- my
kit doesn't have the "elephant butt" wheel housings so I received two
sheets of 1/4" material and no instructions. Thankfully I have a number of
photos from different sources.
The sheets, P/N 1026A and 1026B vary in the fabric orientation-
A is 0-90 and B is +/-45 degrees. I asked the factory and was told to use the
0-90 for the baggage area, but the photos of various projects show everyone
using the +/-45 material. Could those who have gone before confirm what they've
used and where?
Also, I checked the archives and found some discussion about moving
the hydraulic power pack forward to the area behind the pressure
bulkhead. Is that a good location in terms of W&B?
Thanks very much- Bill Wade
|