TSIO 550 guys and or smart engine guys:
I am having a vibration issue and want to see if anyone has
ideas on what to look for. Basically, at takeoff and climbout to around
10,000’, the motor and prop are very smooth and strong. There is no
vibration (prop very recently balanced) and all numbers are normal. As I
pass above 10k to the low flight levels, a vibration in the motor starts to
develop, and when I level off and set the engine for cruise (LOP, 18gph, 34
MAP, 2500 RPM) the vibration is at its worst. It’s almost like the prop
is out of balance, which is why I had the prop balanced at 2500 rpm.
Speeds are good and all engine numbers are normal, no changes. This will
remain for an hour or 2, then the motor seems to magically smooth itself out.
On descent and landing, motor seems smooth and all numbers are normal. Very
recently, on a 4.5 hour flight, about 3.5 to 4 hours in the vibration slowly
came back. I don’t know what to blame, and my motor mechanic is looking
at me funny. I should note that at no time do I think the vibration is
horrible or unsafe, just annoying. I can feel it in the stick and see it
in the panel when its happening.
Things I have ruled out:
Balance of the prop
Dirty plugs or fuel injectors (new plugs and cleaned injectors)
Speed effect (increase or decrease speed has no effect)
Fuel issues
Flight control flutter or anything like that
Things that have been suggested:
A bad valve in a cylinder that doesn’t show until you get to
altitude,
Or bad compression in a cylinder that comes and goes (all cyl’s were comp
tested a month ago though)
Turbo controller not scheduling properly as you climb
Fuel injection system malf?
I’m hoping one of you has had this problem and can point me
and the mechanic to the possible culprit. Appreciate any
comments
Bob Rickard
IV-P