Sender: <marv@lancaironline.net>
To:  lml@lancaironline.net
Date: Sun, 31 May 2009 19:04:59 -0400
Message-ID: <redirect-3659418@logan.com>
Received-SPF: none
 receiver=logan.com; client-ip=68.142.206.142; envelope-from=mcmess1919@yahoo.com
DomainKey-Signature: a=rsa-sha1; q=dns; c=nofws;
  s=s1024; d=yahoo.com;
  h=Received:X-Yahoo-SMTP:X-YMail-OSG:X-Yahoo-Newman-Property:From:To:References:In-Reply-To:Subject:Date:Message-ID:MIME-Version:Content-Type:Content-Transfer-Encoding:X-Mailer:Thread-Index:Content-Language:x-cr-hashedpuzzle:x-cr-puzzleid;
  b=wEhXMFbfT7jWDxYrAE3K7nIl/hBLGNpJ7YuY13Db0gAMWznoacwj7T2apVzJ2sxYn4vMyISa8IgnXYRW84fXoFTSIcyRI/OEE/Vve2RpsSL34UWYaLR6MeR+U+G++SUR02r2WjEnXzk/+Laci7ROQQ1H3SkpF6fz1fOD4ZaZkR0=  ;
From: "Steve Colwell" <mcmess1919@yahoo.com>
References: <list-3659170@logan.com>
In-Reply-To: <list-3659170@logan.com>
Subject: Leading Edge Tape
MIME-Version: 1.0
Content-Type: text/plain;
	charset="US-ASCII"
Content-Transfer-Encoding: 7bit
Thread-Index: AcniHPHFXjkFPxrZR3CD4qtfo1CLuQAClrxw
Content-Language: en-us


The tight radius of leading edges allows air voids to remain during the
molding process even with vacuum bagging.  If you are still building or plan
to repaint, take a sharp punch and tap the leading edges thoroughly.  I
found some voids that were easily broken thru.  First, scuff the surface
well enough with 40 grit so when the voids are patched you can paint on a
couple of coats of clear resin to provide additional protection for
pinholes. West System epoxy is more flexible and is easier to sand than
Jeffco. This is a tip from Don Goetz, Lance's original employee, test pilot
extraordinaire and multi-lancair builder.  I avoid rain so I have not tested
it yet.

Steve Colwell  Legacy