Anybody going thru this step or remember how they did it please email.

I am installing the Elevator push/pull tubes and the pivot assembly with the bob weight.   If I set the sticks to vertical and line up the FWD rod end bolt below the 1/4" pivot bolt and make it accessible thru the oval cutouts the Bob weight does not go to the dimensions in the plans with stick movement.
The plans say the bob weight should stop about 1/4" above the rear push/pull tube at full fwd stick.  Mine stops about 5 inches above it.  I get full travel to my elevator stops and everything works properly but this bob weight dimension.  Is there any cause for re-work on this matter?

Thanks
Bryan