In a message dated 4/7/06 10:38:59 P.M. Eastern Daylight Time,
cberland@systems3.net writes:
"I find I have a slight interference on the
inside edge of the right side tire and the gear door cutout. I would estimate
of about 0.5 inch. The left tire misses the cutout by about 0.75 inch. The
location is just before the end of the hinge, so can not simply grind the
fuselage for the clearance. Any
Suggestions?????
You might want to check your toe in and Caster/Camber with the gear
down. If it is not correct, it can be changed with special shims from
Lancair. This changes the tire position quite a bit where the gear goes
into the fuselage.
Tom Byrnes Lancair IV N54TB