In a message dated 11/11/2005 9:57:51 A.M. Central Standard Time,
MikeEasley@aol.com writes:
I have a JPI EDM 900. If I wanted to relocate my OAT probe to
another location, can I extend the wires, special wire? One of the
reasons I put it inside the ram air duct is I wasn't sure if I could extend
the wire length without throwing off the
measurement.
Mike,
If this is the device:
Then is has short leads that must be wired into some cable to reach the
analyzer. Unless there is a requirement for fixed length cabling, any high
quality wire of reasonable length should work. Note their comments on
getting the probe away from heat sources.
Perhaps a call to their tech dept would get you an answer from the horse's
mouth direct to your ear:
Oops, looks like e-mail contact for tech support - direct from their finger
to your eyes.
Scott Krueger
AKA Grayhawk
Lancair N92EX IO320 SB 89/96
Aurora, IL
(KARR)