Sender: <marv@lancaironline.net> (Marvin Kaye)
To: lml
Date: Sun, 10 Nov 2002 19:00:08 -0500
Message-ID: <redirect-1857564@logan.com>
From: "Mike Hutchins" <mhutchins@attglobal.net>
Reply-To: <mhutchins@attglobal.net>
Subject: Smart Level Zeroing for Angle Determination
MIME-Version: 1.0
Content-Type: text/plain;
	charset="iso-8859-1"
Content-Transfer-Encoding: 7bit
Importance: Normal
In-Reply-To: <list-1648530@logan.com>

List:

I don't recall who wanted to know about the above topic:

To Zero your SmartLevel for normal use:

     1) Turn on level and place in a flat spot. Wait 10-15 sec.
     2) Press and hold RESET until CAL1 appears
     3) Rotate level end for end and wait 10-15 sec.
     4) Press and hold RESET until CAL2 appears. You are now ready to work

To Zero your SmartLevel for relative angle determination:

     1a) Perform Step 1 above in the baseline position, such as the elevator
at full down
     2a) Perform Steps 3-4 above, but DO NOT rotate end for end, leave it in
the same position
     3a) Angle measurements will now be relative to the baseline angle in
1a.

I hope this helps.

Regards,
Mike Hutchins
IV-P Wannabee