To: lancair.list@olsusa.com
Date: Wed, 24 Oct 2001 18:58:04 -0500
Subject: Re: Static on LNC2
Message-ID: <20011024.185804.-16482319.0.Earl_Schroeder@juno.com>
MIME-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit
From: earl_schroeder@juno.com
Reply-To: lancair.list@olsusa.com

          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
          <<  Lancair Builders' Mail List  >>
          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> 
>>
Hi John,
I used the complete PPG base coat clear coat paint system including the
K-36 primer/sealer on the advice of Joe Penaz (the unofficial Lancair
paint advisor).  I used a gravity feed HVLP DeVilbus (sp) which used a
zip loc bag in the cup so one could paint upside down.
I would recommend searching the archives for Joe's articles which helped
me very much since I had never painted with anything but an aerosol can. 
I don't have a 'show' airplane but have received numerous compliments on
the paint job.

Problems:  it takes way too much time so one is tempted to quit the block
sanding too early.  

What I would do differently:  build my hangar first so I would have a
clean, heated and well lit place to paint.
I would also 'beef' up the lower half of the cowl more in the exhaust
pipe area and the area next to the cyl heads since I will eventually have
to repaint it.  I probably did not allow enough clearance in those areas
for the higher heat.... I used the short cowl with a 0-320 engine and it
is a tight fit.  (235/320 airframe)

Earl E Schroeder Lancair N233EE Cessna N3595J

> We are building a Super ES and are thinking about using the
> PPG paints. Did you use their primers as well? If so, were
> there any problems with the primers (sanding & pre-paint.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
LML website:   http://www.olsusa.com/mkaye/maillist.html
LML Builders' Bookstore:   http://www.buildersbooks.com/lancair

Please send your photos and drawings to marvkaye@olsusa.com.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>