<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
          <<  Lancair Builders' Mail List  >>
          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
>>
Clarifications requested:

>From Dan Schafer -- Tighten the B-nut by hand until snug, then 1-1.5 FLATS or
1-1.5 TURNS?  I know you said FLATS, but that would be about 1/4 TURN.  That
seems too little but 1.5 turns seems too much.

>From Bob Smiley -- What temperature do you need to get to anneal the
aluminum?  My household oven goes to 500 F or so.  Will this do?  (Obviously,
with this approach I need to wait until my wife is out of the house...)

>From Walt Dodson -- I have a Parker Rolo-Flair tool which I bought new at
Oshkosh for about $60-70.  Is this the cheap tool, the double lap tool, or
what?  It has a 3-lobed cone that spins with a hand-cranked lever and is
slowly pushed into the end of the tube.  It is not one of those "turn the
wrenches" $15 flaring tools.  Seems to work well enough....

Thanks guys.

- Rob Wolf
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
LML website:   http://www.olsusa.com/mkaye/maillist.html
LML Builders' Bookstore:   http://www.buildersbooks.com/lancair

Please send your photos and drawings to marvkaye@olsusa.com.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>