From: RWolf99@aol.com
Message-ID: <124.200bd18.288b50d2@aol.com>
Date: Sat, 21 Jul 2001 17:40:34 EDT
Subject: Hydraulics
To: lancair.list@olsusa.com
MIME-Version: 1.0
Content-Type: text/plain; charset="US-ASCII"
Content-Transfer-Encoding: 7bit
Reply-To: lancair.list@olsusa.com

          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
          <<  Lancair Builders' Mail List  >>
          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> 
>>
Clarifications requested:

>From Dan Schafer -- Tighten the B-nut by hand until snug, then 1-1.5 FLATS or 
1-1.5 TURNS?  I know you said FLATS, but that would be about 1/4 TURN.  That 
seems too little but 1.5 turns seems too much.

>From Bob Smiley -- What temperature do you need to get to anneal the 
aluminum?  My household oven goes to 500 F or so.  Will this do?  (Obviously, 
with this approach I need to wait until my wife is out of the house...)

>From Walt Dodson -- I have a Parker Rolo-Flair tool which I bought new at 
Oshkosh for about $60-70.  Is this the cheap tool, the double lap tool, or 
what?  It has a 3-lobed cone that spins with a hand-cranked lever and is 
slowly pushed into the end of the tube.  It is not one of those "turn the 
wrenches" $15 flaring tools.  Seems to work well enough....

Thanks guys. 

- Rob Wolf
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
LML website:   http://www.olsusa.com/mkaye/maillist.html
LML Builders' Bookstore:   http://www.buildersbooks.com/lancair

Please send your photos and drawings to marvkaye@olsusa.com.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>