Mailing List flyrotary@lancaironline.net Message #66648
From: David COOK hoursaway1@comcast.net <flyrotary@lancaironline.net>
Subject: Re: [FlyRotary] Re: [Flyrotary] Re: RD-1C input shaft oil seal
Date: Sat, 27 Feb 2021 20:04:13 -0500 (EST)
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Rodger that, good to hear. I'll keep the info on the bearings in case we need them, were ok for now.
On 02/27/2021 9:03 AM Bobby Hughes BHughes@qnsinc.net <flyrotary@lancaironline.net> wrote:
 
 

Made it through the storm fine with a little preparation. Three days without water but no busted pipes and we didn’t lose electricity. This bearing was used to replace the input shaft bearing stack by some of us who were experiencing input shaft wear. It replaced two 2mm bearings and a 1mm thrust washer. Not a lot of collective hours yet. I think Dennis has about 60 hours on the new bearing.

 

Bobby

 

From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]
Sent: Friday, February 26, 2021 5:10 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: RD-1C input shaft oil seal

 

That would be output shaft RPM at the prop that we would be concerned with. So these would fall well within our needs. Do you know if they fit the RD-1B ? Did you weather the storm ok in Texas?

On 02/26/2021 8:59 AM Bobby Hughes BHughes@qnsinc.net <flyrotary@lancaironline.net> wrote:

 

 

Finn,

 

Steve posted a picture of three different 5mm bearings back in 2019. The AZK35525 I ordered and received has a bronze inner and steel outer race. I have no idea on the oil seals.

 

Bobby

 

From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]
Sent: Thursday, February 25, 2021 3:28 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: RD-1C input shaft oil seal

 

Thanks Bobby!

When I Google AZK35525 most pictures don't show any races. Not included?

Any significant difference between the Timken and National 350909 seals?

Finn

On 2/25/2021 3:59 PM, Bobby Hughes BHughes@qnsinc.net wrote:

Finn,

 

A few us are / were using the bearing Steve identified. I had 34.5 hours on the new bearing when I sold the RV10. The bearing still look new.

 

 

5MM needle cage assy  bronze inner race / steel outer race 35mm    AZK35525

35mm

52mm

5mm

 

7000 rpm

 

My oil seal was leaking and replaced at the same time as the 5MM bearing. The leak was only detectable at idle. A small streak of oil was form below the seal. In flight the oil would blow everywhere making it impossible to located the source.

 

350909

Rear Oil Seal  National Oil Seal

 

 

Bobby – S21 kit has arrived.

 

From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]
Sent: Thursday, February 25, 2021 12:46 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] RD-1C input shaft oil seal

 

So there's a bunch of posts of input shaft oil seal failures.

But what is the recommended oil seal?

I think I've traced my oil leak to that. (Tricky because found drops on
fittings near oil filter base after last flight. But after wrapping
paper towels around the fittings and doing a ground run-up, only traces
of oil is on the outside of them -- likely slung up from the input shaft).

On a different note. January last year I bought a  “INA 81107TN
Cylindrical Roller Thrust Bearing, Polyamide Nylon Cage, Open End,
Metric, 35mm ID, 52mm OD, 12mm Width, 6500rpm Maximum Rotational Speed”
on Amazon for $18.40 to replace the input thrust bearings on my RV-3B.
(The stacked bearings are cutting a groove in the shaft.) Now the same
bearing set costs $135 and up. WTF! Did find SKF 81107TN on eBay for
$30.50. But dang! No inflation?

Finn


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus


--
Homepage: http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html

 

Disclaimer

The information contained in this communication from the sender is confidential. It is intended solely for use by the recipient and others authorized to receive it. If you are not the recipient, you are hereby notified that any disclosure, copying, distribution or taking action in relation of the contents of this information is strictly prohibited and may be unlawful.

This email has been scanned for viruses and malware, and may have been automatically archived by Mimecast Ltd, an innovator in Software as a Service (SaaS) for business. Providing a safer and more useful place for your human generated data. Specializing in; Security, archiving and compliance. To find out more Click Here.

 

 


Image removed by sender. Avast logo

This email has been checked for viruses by Avast antivirus software.
www.avast.com

 

--
Homepage: http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html

Image
image001.jpg
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster