Charlie and Mark,
Yes Charlie the accessory "iron" side housing is what would be replaced with an aluminum housing with built in mount points that replicate the Lycoming O/IO 540 mount ears and locate the Mazda eccentric
shaft centerline in the same place as the Lycoming crankshaft centerline and make the Mazda a bolt in to any aircraft using the O/IO 540 30 degree "Dyna1" mount system.............
Mark I am well aware of the different opinions on using the rear dyna focal mount on the Mazda.........Bill is correct about the need for .500 in/12.5mm studs and a stiffening plate and/or rigid oil sump to
further resistance to torsional twisting..........But remember that the O/IO 540 family of engines with firewall forward weights of 400+ to over 500 lbs for some turbo models are all using this mount system and
that an all alloy 13B or 20B (even with reduction drive) will be much lighter..........I do not believe that the "Mistral" 13B or 20B used alloy housings for other than the front accessory housing and I have never
heard if they used the oversize .550 inch/12.5 mm studs in any of their engines..........This is probably a question that will have to be proven one way or another in actual use..........IMHO
Best
Kelly Troyer
Wonder why Mistral used dynafocal type mounting on their 13b and 20b designs?
M
Sent from my iPad
Kelly,
The "dynafocal" type mount has been tried on the rotary but has not worked out well..One of the obvious rotary traits is that it has a hot and cold side. Various methods have been used to limit this but there is no way to eliminate it completely. Because of this the engine tends to "work" and move around on the studs. Using the engine as a stressed member is not recommended with the rotary. If you were to do this anyway I wouldn't do it without a stud kit. You will have better results using a bed mount. YMMV
Bill Jepson
I am in contact with a person with the design and manufacturing capability to produce an Aviation Specific 13B/20B Mazda Front Side Housing machined from 7075-T6 with mount points that would allow these engines
to be a bolt in to the engine mount ring (30 degree number 1 Dyna) as used by the "Vans" RV-10 and other aircraft that use the Lycoming O/IO 540 engine..........This side plate is in the preliminary design stage and at this
point I am a go between to see if there would be any interest in this product if and when it is produced...........I personally am interested this side plate........As we on this forum know both the 13B / 20B are capable of truly
amazing power levels both naturally aspirated and turbo boosted.........The 20B would make the Van's RV-10 , Glasair 3 or Lancair's that use the Lycoming O/IO 540 an easy 300+ hp almost bolt in engine...........
The "Reno" Sport Class "Glasairs" and Lancairs" are producing almost 400 mph speeds using dual turbo Lycoming IO-550 engines that are virtual hand grenades pulling over 700 hp...........There are turbo 20B's pulling
1200 hp out in the auto racing world with good reliability..........A 20B boosted to 700+ hp is not even breathing hard.........IMHO
Would like to hear what interest there may be in this product if and when it may be produced............Or any comments pro or con..............
--
Kelly Troyer