flyrotary@lancaironline.net Mailing List Archive

Hi Rich I should have mentioned that the EC2 & 3 documents I have are both for the A8 versions. Steve > On 26 Jan 2020, at 8:15 pm, Stephen Izett stephen.izett@gmail.com <flyrotary@lancaironline.net> wrote: > > Hi there Rich > > In the EC3 code it suggests that the BUSENSOR can be programmed on various engines: > "BUSENSOR EQU 0x00 ;0 = NO BACKUP SENSOR, 1 = BACKUP INSTALLED (0xA8,0xA9,AB,AD,B1,B2,B4 0-200 ENGINE ONLY)" > But in the EC3 document I have, the pinout reads: > "Pin 6. Crank Angle Sensor (CAS) 2 Destination. Not Applicable on this version. (OPTIONAL)" > Also in the Document. > "Note, This version of the EC3 controller is not available with the optional backup crank sensor even though it is shown in the schematic." > In both the EC2 & 3 documents I have under Sensor wiring it says: > "If you have installed a backup sensor and have ordered the EC2 with the backup sensor option, the backup sensor must be mounted 90 degrees in advance of the primary sensor. > > Cheers > > Steve Izett > > >> On 26 Jan 2020, at 10:14 am, A R Goldman argoldman@aol.com <flyrotary@lancaironline.net> wrote: >> >> Not a timing issue directly,however— >> >> I have Tracy’s ec3 for my renesis. The wiring diagram indicates an input for two CASs however in my rapidly fading memory I seem to remember that only one CAS can be used. Is that correct or can it read two 180 degrees off set. >> >> Thanks, Rich >> >> Sent from my iPhone >> >>> On Jan 25, 2020, at 6:25 PM, Stephen Izett stephen.izett@gmail.com <flyrotary@lancaironline.net> wrote: >>> >>> Hi guys >>> >>> My apologies, I think Ive asked this some years back, and I’ve had trouble searching the archive, not sure why! >>> >>> Lynn has talked from memory about the importance of knowing the timing. >>> So much appreciate your input Lynn over the years, and sorry for the times I haven’t listened carefully. >>> >>> Tracy’s A8 Renesis base timing setup has always run well. >>> But now as we are extending the envelope I’m interested in what others with Renesis engines/CAS have done with their timing. >>> >>> Can anyone with EC2/3 A8 and Renesis CAS comment on any timing adjustments that have made to the base settings. >>> >>> Thanks >>> >>> Steve Izett >>> >>> >>> >>> -- >>> Homepage: http://www.flyrotary.com/ >>> Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html >> >> >> -- >> Homepage: http://www.flyrotary.com/ >> Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html > > > -- > Homepage: http://www.flyrotary.com/ > Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html