Bobby,
So that switches the EM-2 out of the system and puts all the input to the 3.5mm jack. Is this because the software must work without
interference? Or does the software interfere with the EM-2? I suppose the other end of the 3.5 mm plug is a USB plug?
Ok, I found the cable at Digikey. Should this be the 5V or the 3.3V? Does it matter?
I hope you guys know what you are doing putting all these ideas into my head! There will be questions!
Bill B
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]
On Behalf Of Bobby J. Hughes
Sent: Thursday, January 24, 2013 7:15 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Hiccup!
I use a jack and switch permanently installed to switch the serial signals between the EM3 and Steve’s software.
Bobby
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]
On Behalf Of Bill Bradburry
Sent: Thursday, January 24, 2013 5:39 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Hiccup!
Steve,
I am a pretty well defined dork when it comes to herding electrons, but pins 16, 7, & 27 appear to be the ground, in and out for the
serial connection to the EM-2. So to make the connection to the computer cable, I could tap these three wires and connect them to the indicated computer cable wires and it would work? It appears that the green and brown wires may be connected together as
well?
I can get the computer cable where? Radio Shack?
Bill B
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]
On Behalf Of Steven W. Boese
Sent: Thursday, January 24, 2013 5:46 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Hiccup!
Bill,
If you think the problem is with the EC2 signals, an example of examining those signals is shown in the following web site:
www.rotarycopilot.com/
in the Start Up Sequence discussion in the Documents section. Although this discussion dealt with an issue that has since been resolved, the data
collection and examination methodology may be helpful for your situation. Using this would depend on being able to collect data during the time that the problem occurred which might take some effort if the problem doesn't happen very often.
It may also be worthwhile to consider setting up the monitoring system described in the Software section of the same website. This system was developed
to troubleshoot my EC2 installation and enables one to verify the operation of the EC2 controls (among other things). In my case, there was a cold solder joint on one of the pins of the mixture control potentiometer of the control board resulting in an intermittent
connection. Watching the EC2 output as the mixture control setting was changed made the problem obvious. The engine didn't even need to be running to find the problem.
Let me know if you want more details.
RV6A, 1986 13B NA, RD1A, EC2
From:
Rotary motors in aircraft [flyrotary@lancaironline.net] on behalf of Bill Bradburry [bbradburry@bellsouth.net]
Sent: Thursday, January 24, 2013 3:09 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Hiccup!
Well the hiccup is much worse now! In fact it is no longer a hiccup. I misses a string of 3-4 in a row and loud backfires! It seems
that it is electrical in nature as the mixture was pretty well centered the whole time and turning the mixture knob didn’t seem to help.
I am thinking about rewiring the entire system, but I am somewhat concerned that I may just screw up something that is not broken.
Didn’t there used to be someone on the list that built wire harnesses for the EC-2?
Suggestions welcomed!
Bill B