|
|
|
Thanks for bringing this up.
We're about to make another batch of these plates. We know there have been
some issues with flywheels/flex plates and it has been quiet for awhile. Is
there a standard aluminum flywheel we are going to be using now instead of the
automatic flex plate? If that is the case we will make the plates with the
appropriate mod in the starter area to accommodate the difference.
Chrissi &
Randi
www.CozyGirrrl.com
ClickBonds
10/$7.50
CG Products, Custom Aircraft Hardware
Chairwomen, Sun-N-Fun
Engine Workshop
In a message dated 1/21/2013 2:17:42 P.M. Central Standard Time,
bhughes@qnsi.net writes:
Might
talk to the Cozygirls,
|
|
CG-RX-RMP Reduction Drive Mounting Plate /
Side Starter
Price: (only
available with complete mounting kit at this time)
Product
Information: Side mount starter type redrive mounting plate for RWS
Redrive.
Includes standoffs, spacers and hardware. Requires Lord
Mount Kit, 13B or 20B Bolt Kit and Tubular
Mount.
|
|
|
|
http://www.cozygirrrl.com/aircraftparts.htm
Bobby
From: Rotary motors in
aircraft [mailto:flyrotary@lancaironline.net] On Behalf Of Bill
Bradburry
Sent: Monday, January 21, 2013 12:43 PM
To:
Rotary motors in aircraft
Subject: [FlyRotary] Re: Moving the
starter from the bottom to the side
I
wonder what the diameter of the three holes are?
Bill
From: Rotary motors in
aircraft [mailto:flyrotary@lancaironline.net]
On Behalf Of Mark Steitle
Sent: Monday, January 21, 2013 1:18
PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re:
Moving the starter from the bottom to the side
Bill,
I moved mine to the 9 o'clock position (plugs side) by
building a whole new plate. Since the bell housing bolts locate the
center position, it requires very accurate locating of the holes as does the
center hole which has a counter-bore for the seal. I cut the plate and a
good friend with a Bridgeport did the holes for reasonable fee. Too bad
Tracy doesn't offer this as an option.
image001.gif
|
|