flyrotary@lancaironline.net Mailing List Archive

OK. I think I have the inboard ring of the Psru out of phase with the outboard housing if both drains are 1/4" Can I t them with -6 fittings. and al tubing before I route the drain to the al rotor housing? Thanks Joe Berki Sent from my iPhone On Aug 23, 2012, at 9:30 PM, Tracy <rwstracy@gmail.com> wrote: > Drilling & taping a hole in the foot of the rear(as in the car) rotor housing is my favorite spot. But the return ports are both 1/4" NPT, not 1/8" NPT on one of them. > > Tracy > > Sent from my iPad > > On Aug 23, 2012, at 7:58 PM, <jskmberki@windstream.net> wrote: > >> Where on a 2nd gen engine is the best place for a oil return line from the PSRU drain? Can I use Al tubing between the 1/4" port and the 1/8" port into a T? >> >> Thanks for any help >> >> Joe Berki >> >> -- >> Homepage: http://www.flyrotary.com/ >> Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html > > -- > Homepage: http://www.flyrotary.com/ > Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html