|
Message
Welding shops carry AL 'brazing rod'. It's melting point is
around 750
degrees, well below AL's.
Charlie
Thanks for the info
Charlie, but it probably won't come down to needing it.
I just made a trip to
the hanger to take my cowl and fiberglass crap back from the garage.
First, I'd like to publicly state that I am an idiot :-)
I took a look at the
wrapover manifold that I was using on the engine previously, and noticed that it
has the same size secondary ports as the straight manifold that I got from
David. In other words, they're both 6-port intakes. I don't know if
that caused me any problems before, but it couldn't have helped. Paul, you
said the straight, and wrapover both matched up well to your ports. Do you
have a 4 or 6 port block? Better hope you have a 4
:-)
Now the good news, I
took another look at the Mazdatrix intake that I was planning to use before, and
found that it matches my 4-port engine quite well. I was copying
this excellent idea from Paul, but gave up when it seemed that it couldn't be
cut low enough to fit under the cowl. Well, with renewed motivation, I
found that it can work as originally planned. I'll really have
to cut it to the minimum, but it will work. This will leave
the TB on the cold side of the engine, basically in the way
of changing the spark plugs. You can't have everything
:-) The other good point is that I can sneak under the
right cheek evap core, and get air from the bottom of the air
duct. I couldn't do that on the left because of the exhaust
pipes.
So, nothing stands
between me, and getting the engine running again, with the exception of my poor
welding skills, and lack of ability to use the mill/lathe
:-)
Cheers,
Rusty (next project
festering)
|