Chrissi,
I did not see an answer to your question about
"Mocal" water to oil coolers...............It has been
reported previously that some have used the "Mocal" model A43-330 cooler
with success........
Some have had custom units built by Ed Klepis at "Tech
-Weld" or other suppliers........... I have
had a 330 for some time but alas I am still grounded
!!.............<:).........See PDF below..........
Kelly Troyer
"DYKE DELTA JD2" (Eventually)
"13B ROTARY"_ Engine
"RWS"_RD1C/EC2/EM2
"MISTRAL"_Backplate/Oil
Manifold
"TURBONETICS"_TO4E50 Turbo
From: "CozyGirrrl@aol.com" <CozyGirrrl@aol.com>
To: keltro@att.net
Sent: Mon, December 13,
2010
12:52:06
PM
Subject: Re: Fw: [FlyRotary] Re: Fw:
Water temps
This is where I
get confused:
-ideal water temp
= 160*~180*F
If we are cooling
oil with water that is at best hotter than the ideal temp of the oil, then
are we not adding heat to it rather than removing it?
If we are trying
to cool oil, why would we feed the highest temp water to the oil/water
cooler rather than the coolest temp water by tapping into the pump housing
where it enters the block?
Based on feedback,
the water entering the block may be as low as 150*~160*F, would this be cool
enough to do an adequate job of cooling the oil?
Also, which model
of Mocal is being used?