|
Hi, fellow rotary enthusiasts. I have a 1989
turbo model 13B. (missing the turbo, however). Today I removed the home made
intake manifold, and to my surprise, anti-freeze started pouring all over the
floor. (Fortunately, I was in the garage instead of the living room) Upon
inspection, I found two holes approximately 3/4 inch in diameter with O-rings on
either side of the center two ports. Can anyone tell me the purpose of these two
holes?
I purchased the fuel
injection and ignition system from Dave Atkins, and the intake
manifold appears to fit very well, but it will effectively block off and/or
seal both of these holes. Just wondering about their purpose. Thanks in
advance for your replies. Paul Conner, Mobile,
AL
|