I replaced my original engine with another newly rebuilt block, and also added the EM-3 to the installation. The old engine was hard to start, and was also making a ticking noise when it did start, which didn't used to be there.

After several failed attempts, and double checking the connections, I had a neighbor help me do some testing.  While the ignition test runs fine, when checking one of the plugs, it sparks when I initially crank the engine, and then stops.  Once in a while there will be another spark, but not very often.

I reinstalled the original CAS and have the same issue.  I have double checked the CAS connections and checked them with an ohm meter to the connector on the EC-2 also. Everything seems to check out, yet I get only that initial spark. I have replaced the spark plugs with new ones, and whenever I pull one to check it, is is wet with fuel, which is no surprise.

I am wondering if anyone has seen this type of problem, or if you have any suggestions.
Regards,
Steve Brooks
Cozy MKIV 13B turbo

--
Homepage:  http://www.flyrotary.com/
Archive and UnSub:   http://mail.lancaironline.net:81/lists/flyrotary/List.html