Mailing List flyrotary@lancaironline.net Message #41910
From: George Lendich <lendich@optusnet.com.au>
Subject: Re: [FlyRotary] Thrust on E-shaft
Date: Tue, 11 Mar 2008 17:21:16 +1000
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
 Message Header

Undecoded Message
John,
That sounds like a lot of dampers out there. I didn't realize Marcotte used that system - how are the opposing sides held together.
George (down under)
Lynn, I have a Marcotte Redrive and the drive disc has 5 pins that appear to have a taper similar to a Morse Taper and the driven disc has isolator bushings, which are internally tapered to fit the pins, of some type to absorb the torisonal vibrations.  Will this setup cause an undesirable load on the thrust bearings.  I was hoping to get a first start when the snow goes, now this question comes up.  JohnD

No virus found in this incoming message.
Checked by AVG.
Version: 7.5.518 / Virus Database: 269.21.7/1324 - Release Date: 10/03/2008 7:27 PM
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster