It's OK with me George. If it works better I'll go for it:)
Buly


-------------- Original message ----------------------
From: "George Lendich" <lendich@optusnet.com.au>
>
> Buly,
> I guess your right, however conventional wisdom on Rotary engine suggest 
> that welding on the inside and tacking on the outside works better with the 
> Rotary high heat exhaust.
> 
> There has been a lot of discussion on this in the past.
> 
> George ( down under)
> 
> > 99% of the aircraft flanges are welded on the outside only.
> > Buly
> >
> >
> > -------------- Original message ----------------------
> > From: hoursaway1@comcast.net
> >>
> >> I thought for best support you are to weld on the inside of pipe/flange. 
> >> David
> >> Cook.
> >>
> >> -------------- Original message -------------- 
> >> From: Bulent Aliev <atlasyts@bellsouth.net>
> >>
> >> > Kevin,
> >> > Racing Beat has very nice cast stainless steel flanges
> >> Buly
> >
> >
> > --
> > Homepage:  http://www.flyrotary.com/
> > Archive and UnSub: 
> > http://mail.lancaironline.net:81/lists/flyrotary/List.html
> >
> >
> > -- 
> > No virus found in this incoming message.
> > Checked by AVG Free Edition.
> > Version: 7.5.503 / Virus Database: 269.17.1/1181 - Release Date: 
> > 11/12/2007 5:05 PM
> > 
> 
> 
> --
> Homepage:  http://www.flyrotary.com/
> Archive and UnSub:   http://mail.lancaironline.net:81/lists/flyrotary/List.html



--
Homepage:  http://www.flyrotary.com/
Archive and UnSub:   http://mail.lancaironline.net:81/lists/flyrotary/List.html