In a message dated 10/25/2007 12:02:57 P.M. Eastern Daylight Time,
bhughes@qnsi.net writes:
I need to smooth
out the airflow inside my upper intake manifold at the transition between one
3" tube and two 2" tubes that form a "Y".
Not sure which one
is best. I have purchased slow cure JB Weld but just can't convince
myself to use it.
Any product
recommendations?
Bobby J
Hughes
The aluminum putty is what I used years ago to build up the sides of Go
Kart engines that I had ported.
Can be drilled and tapped like an aluminum block. Wear plastic gloves. It
doesn't come off. Scuff up the surface where you want it.
Lynn E. Hanover