|
Hi All
The post above is a friend of mine that is very
frustrated right now. I realize that this is an aviation based forum, but
thought that this would be the best place to start.
He is running a stock 13B in his RX7 and as he
said, swapped out the block, but left the rest alone. Reason for the block swap
was a blown cooling seal in the #1 chamber which resulted in a short duration
high temp situation. Just wondering, if he may have burned out the O2 sensor,
could this be a cause for the lack of low idle?
Thanks for any help,
Shane Daly
Glasair 1TD
13B Turbo
----- Original Message -----
Sent: Thursday, September 06, 2007 10:04
AM
Subject: [FlyRotary] Idel issues
I just swaped my block out its a 13b non
turbo . last block ran fine idled fine.but for some reason this one
will not idle below 2 thousand rpm.any suggestions on what i missed or
direction to go in?
kevin
No virus found in this incoming message.
Checked by AVG Free
Edition.
Version: 7.5.485 / Virus Database: 269.13.7/992 - Release Date:
9/6/2007 8:36 AM
|