Received-SPF: none
 receiver=logan.com; client-ip=211.29.133.218; envelope-from=lendich@optusnet.com.au
Message-ID: <004701c7cd7d$1cc754e0$c656693a@george>
From: "George Lendich" <lendich@optusnet.com.au>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
References: <list-2194419@logan.com>
Subject: Re: [FlyRotary] Re: carbs vs efi
Date: Tue, 24 Jul 2007 08:59:22 +1000
MIME-Version: 1.0
Content-Type: text/plain;
	format=flowed;
	charset="iso-8859-1";
	reply-type=original
Content-Transfer-Encoding: 7bit

Buly,
I will shoot of an e-mail, I have broadband.
George ( down under)

>> > George, if you are asking about 13B PP factory housings, I have  couple 
>> > of
>> > them in the hangar.
>> > Buly
>>
>> Buly,
>> It would be excellent if you could measure them for me, what I need is 
>> the
>> inlet ID and let me know where the port is placed - using whatever
>> references that is easiest for you. A photo would be good too.
>> George ( down under)
>
> George,
> I took 4 pictures, but I don't know if the list will accept 4 photos at 
> the same time. I can send them directly to you if you send me your email 
> address to mailboxb at bellsouth.net.
> The outside diameter of the port is 43mm the top inside wall is parallel 
> to the base of the housing (90 degree to the outside if the mounting 
> flange. The bottom slopes downward.
> The inside opening is 43mm wide but 50mm tall. It is round at the top and 
> straight at the bottom. When you see the photos you'll know.
> Buly
>
>
> --
> Homepage:  http://www.flyrotary.com/
> Archive and UnSub: 
> http://mail.lancaironline.net:81/lists/flyrotary/List.html