-------------- Original message from <atlasyts@bellsouth.net>: --------------


>
> >
> > From: "George Lendich"
> > Date: 2007/07/23 Mon AM 12:06:56 EST
> > To: "Rotary motors in aircraft"
> > Subject: [FlyRotary] Re: carbs vs efi
> >
> > >> Yes, but I have never seen one.
> > >>
> > >> Lynn E. Hanover
> > >>
> > >>
> > >>
> > >> Get a sneak peek of the all-new AOL.com.
> > >
> > > George, if you are asking about 13B PP factory housings, I have couple of
> > > them in the hangar.
> > > Buly
> >
> > Buly,
> > It would be excellent if you could measure them for me, what I nee d is the
> > inlet ID and let me know where the port is placed - using whatever
> > references that is easiest for you. A photo would be good too.
> > George ( down under)
>
> George,
> I took 4 pictures, but I don't know if the list will accept 4 photos at the same
> time. I can send them directly to you if you send me your email address to
> mailboxb at bellsouth.net.
> The outside diameter of the port is 43mm the top inside wall is parallel to the
> base of the housing (90 degree to the outside if the mounting flange. The bottom
> slopes downward.
> The inside opening is 43mm wide but 50mm tall. It is round at the top and
> straight at the bottom. When you see the photos you'll know.
> Buly
>
>
> --
> Homepage: http://www.flyrotary.com/
> Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html