|
Message
Rusty,
WHAT reinforcing ring ?
George ( down under)
Hi
George,
The ring I'm
referring to is about an inch wide (didn't measure it), and perhaps 1/16" thick
steel. The ID is the same as the hole in the center of the
flexplate, and it has the bolt holes in it of course. Basically, it's just
a clamping ring. I'd bet that you can look at your stock flexplate, and
see where it used to be. From conversations I've had with Tracy, I
believe it's considered "nice", but not essential. You could just use
some large washers instead.
Cheers,
Rusty (glad
it's not Tuesday morning here)
|