|
Bill,
That's used in other devices that are sometimes difficult to separate. The
only problem I see is that your driving your bolt into aluminium, so some
care would need to be taken.
George ( down under)
> I am about to install my RD-1C PSRU (as soon as I can get the correct
> flex plate.)
>
> I was reading the instructions and there were some warnings about the
> difficulty of breaking the sealant between the drive and the mounting
> plate. I know that at some point, I will need to disassemble the drive
> and it will be difficult to separate the mounting plate from the drive
> housing.
>
> What would be wrong with adding a few tapped holes between the existing
> holes in the bolt circle of the mounting plate? When is comes time to
> separate the plate, I would just screw in a few bolts into these holes
> and tighten them in sequence. This would push the drive housing away
> from the mounting plate in a controlled manner. No hammers, pry bars,
> or bad language required.
>
> Am I missing something, or is this a good idea?
>
> Bill Dube'
>
>
>
>
> --
> Bill Dube'
> BillDube@KillaCycle.com
>
> --
> Homepage: http://www.flyrotary.com/
> Archive and UnSub: http://mail.lancaironline.net/lists/flyrotary/
>
|
|