Mailing List flyrotary@lancaironline.net Message #28623
From: Buly <atlasyts@bellsouth.net>
Subject: Re: [FlyRotary] Re: Fuel filters
Date: Tue, 20 Dec 2005 12:43:42 -0500
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Al, this photo is more than a year old and that was the beginning of the engine installation. 
Anywho, I better go to the hangar and get some details taken care of for the DAR inspection. No more tips for today. You are on your own :)
Buly
On Dec 20, 2005, at 12:29 PM, al p Wick wrote:

Clean looking install! I worked in tubing industry for a few years. I see
some hard plumbed tubing at turbo and psru that might benefit from strain
relief closer to termination point. I guess. High stress at those points.
Fire it up with covers off and use strobe light to see movement. Most
illuminating.


-al wick
Artificial intelligence in cockpit, Cozy IV powered by stock Subaru 2.5
N9032U 200+ hours on engine/airframe from Portland, Oregon
Prop construct, Subaru install, Risk assessment, Glass panel design info:

Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster