|
Thanks to all on the Injector
information.
I will follow-up on those costings.
It would seem their all pretty expensive but I will
look at the MSD.
The price locally was about $130 for 400's(
primary), to $230 for the 550's ( secondary) - which I think is too
expensive.
George (down under)
George,
If you’re not
planning on installing them in the stock location in the intake ports, then
you could use Ford Mustang injectors. They come in sizes starting at
19lbs/hr on up. I chose the 42.5 lb/hr units as they flow about the same
as the 460cc n/a Mazda units. I ran them at low power for a couple of
hours, but I ended up using the Mazda injectors after all due to other design
reasons. They’re readily available for a pretty reasonable
price.
Mark S.
From: Rotary
motors in aircraft [mailto:flyrotary@lancaironline.net] On Behalf Of George Lendich
Sent: Monday, September 19, 2005 4:11
AM
To: Rotary motors in
aircraft
Subject: [FlyRotary]
Injectors
I've established type of injector
and capacity of Injectors for primary and secondary, I established type of
coils - thanks to everyone for their input.
I have established costs and
availability of coils, However I haven't established costs of Injectors -
local prices are a bit over the top, does any one have any suggestions as to
what price to expect to pay, for injectors and who supplies
what?
|